HANDSETS FOR TACTICAL RADIO EQUIPMENT.

H-189/GR HANDSET is a rugged, repairable unit, molded out of polycarbonate lexan. It can be utilized interchangeably witch the H-250 handset.

• Military Specification: MIL-H-55258B (EL), MIL-H-49078 (EL)
• Color: Black.
• Earphone: 1000 ohm.
• Microphone: 150 ohm.
• PTT Switch: Witch make/ break sequence.
• Cable: 12" retractable coiled cord extends to approximately.
• Terminated witch a U-229/U connector.

H-250/U HANDSET is a Microphone-Receiver Handset used for tactical field communications requirements. It is manufactured to U.S. Military Specifications and is normally utilized with Military Man-Pack Radio Equipment, such as AN/PRC-77 etc. The Microphone Element in this handset H-250 is noise canceling. The Handset is equipped with a Press-To-Talk switch and 6 feet (extended) retractile cord, terminating in a 5 pin audio connector (U-229U).

• Color: Black
• Earphone: 1000 Ohms as per MIL-PRF-49078
• Cable: 14” Retractable coiled cord (SM-D-627669) extends to approximately 6ft; standard termination is U-229/U connector.
• Microphone: 150 Ohms as per  MIL-PRF-49078
• Switch: Push-to-Talk with Make/Break sequence SM-C-627671

H-350/U HANDSET is now the standard handset used for tactical field telephone sets. It is utilized with both analogue and digital voice terminals such as the TA-954/TT Digital Non-Secure Voice Terminal. Unlike its twin brother, (the H-250/U), the H-350/U is not compatible with radio equipment sporting 6 pin audio connectors. The principle design of this handset is to provide 'hot mic' capabilities thus allowing for full-duplex operation over telephone circuits. This is accomplished by changing the method by which the microphone is wired to the PTT switch and by the addition of an extra ground lead to the microphone capsule and pin F of the audio connector. The H-350/U features a press-to-net radio interface switch for activating remote radio transceivers, a retractile cord and is terminated with a 6 pin audio connector.

• Other spec’s are similar to H-250/U Handset.

H-207/VRC HANDSET consists of a microphone, receiver, PTT switch and transformer mounted in a high-impact plastic case for transmitting and receiving voice-frequency signals. The microphone has two elements, each under a separate opening, for cancellation of outside noise. The H-207/VRC is utilized primarily for infantrymen outside a tank, an armored personnel carrier or a vehicle, for the purpose of communicating to those crew members inside. The cord assembly is terminated with five spade lugs that mount to a remote-control box, generally designated as the C-2296/VRC control box.

• Cable: Rubber jacketed coiled length 122cm (48inch) Extended 610cm (240inch)
• Switch: Push-to-Talk with Make/Break sequence

H-207A/VRC HANDSET is designed to replace the officially obsuleteH-207/VRC. The H-207A/VRC is functionally interchangeable with H-207/VRC (However components/parts are not interchangeable.

• Color: Black
• Earphone: 1000 Ohms per MIL-PRF-49078A
• Cable: 20’ Extended rubber jacketed cable terminated with AMP spade lugs.
• Microphone: 150 Ohms per MIL-PRF-49078A
• Switch: Push-to-Talk with Make/Break sequence

H-60/PT HANDSET The H-60/PT is a communications handset with an integral push-to-talk switch. It is manufactured to US military standards and is ruggedized for use in extreme environmental conditions. The handset is supplied with a 1.8 m (extended) retractile cord assembly, terminating in solder less terminals. The H-60 contains built-in circuitry to limit maximum acoustic output of the handset receiver and to prevent receiver element damage caused by high transient voltages.

This handset is intended for use with wire and radio communication equipment in locations with extreme environmental conditions. The handset H-60/PT is also being used with tactical intercom stations and field telephones.

M-80C/U MICROPHONE is a handheld microphone molded in polycarbonate lexan. This is a standard microphone used for tactical field communications equipment. It is utilized with man pack and fixed station radio and telephone equipment. The M-80C/U features a press-to-talk switch, a retractile cord and is terminated with a 5 pin U-229U audio connector. The microphone is of the noise-cancelling type. 
SPECIFICATION: PER MIL-E-55119A
Cable: 12" Retractable coiled (5 conductors) Extends to approximately 6ft.